1. <listing id="26ji2"><object id="26ji2"><p id="26ji2"></p></object></listing><var id="26ji2"></var>
      2. <listing id="26ji2"></listing>
        <meter id="26ji2"><strong id="26ji2"><acronym id="26ji2"></acronym></strong></meter>
        1. 
          

            <tt id="26ji2"></tt>

                1. <output id="26ji2"><button id="26ji2"><address id="26ji2"></address></button></output>
                    <output id="26ji2"><pre id="26ji2"><dd id="26ji2"></dd></pre></output>
                        <meter id="26ji2"><delect id="26ji2"></delect></meter>
                          <label id="26ji2"></label>
                            <mark id="26ji2"><button id="26ji2"></button></mark>

                              <mark id="26ji2"><button id="26ji2"><address id="26ji2"></address></button></mark>

                              1. <listing id="26ji2"><object id="26ji2"></object></listing>

                                  <tt id="26ji2"><pre id="26ji2"></pre></tt>
                                  1. <label id="26ji2"><ruby id="26ji2"></ruby></label>
                                  2. <mark id="26ji2"><pre id="26ji2"></pre></mark>

                                  3. <code id="26ji2"></code>

                                  4. <tt id="26ji2"><wbr id="26ji2"></wbr></tt>

                                    <blockquote id="26ji2"></blockquote>
                                  5. <label id="26ji2"><button id="26ji2"></button></label>
                                    
                                    

                                      1. <mark id="26ji2"></mark>
                                        <output id="26ji2"></output>

                                        氣瓶水壓試驗機的兩種控制方式步驟介紹

                                        2014-10-20 0

                                        氣瓶水壓試驗機的兩種控制方式步驟介紹:

                                        一、手動控制

                                        1、檢查控制氣管路,以及被測試產品是否已經連接好;

                                        2、“手/自動”轉換開關處于“手動”位;

                                        3、按下"開"按鈕,三個旋轉氣缸動作,夾緊水套與蓋;

                                        4、按下"填充"按鈕,增壓泵開始工作,進行管路填充與排氣,打開水套上方的手動閥門進行排氣,完成后,關閉閥門,并再次按下"填充"按鈕;記錄電子秤讀數;

                                        5、按下"升壓"按鈕,此時增壓泵開始工作,觀察高壓壓力表,當達到試驗壓力后,按下"保壓"按鈕;系統進入保壓狀態;

                                        6、達到保壓時間后,記錄電子秤讀數;然后按下“卸荷” 按鈕,卸去泵出口壓力;觀察輸出壓力表為零后,再拆卸工件。

                                        如有緊急情況直接按下“急停”按鈕,系統停止工作并卸壓

                                        二、自動控制

                                        1、檢查控制氣管路,被測試產品是否已經連接好;

                                        2、將“手/自動”轉換開關處于“自動”位;

                                        3、進入軟件主界面;

                                        4、開始試驗之前設定壓力、時間等參數;

                                        5、按照步驟:設置參數、開始、停止、導出、退出進行試驗。

                                        北京赛车计划数据
                                            1. <listing id="26ji2"><object id="26ji2"><p id="26ji2"></p></object></listing><var id="26ji2"></var>
                                            2. <listing id="26ji2"></listing>
                                              <meter id="26ji2"><strong id="26ji2"><acronym id="26ji2"></acronym></strong></meter>
                                              1. 
                                                

                                                  <tt id="26ji2"></tt>

                                                      1. <output id="26ji2"><button id="26ji2"><address id="26ji2"></address></button></output>
                                                          <output id="26ji2"><pre id="26ji2"><dd id="26ji2"></dd></pre></output>
                                                              <meter id="26ji2"><delect id="26ji2"></delect></meter>
                                                                <label id="26ji2"></label>
                                                                  <mark id="26ji2"><button id="26ji2"></button></mark>

                                                                    <mark id="26ji2"><button id="26ji2"><address id="26ji2"></address></button></mark>

                                                                    1. <listing id="26ji2"><object id="26ji2"></object></listing>

                                                                        <tt id="26ji2"><pre id="26ji2"></pre></tt>
                                                                        1. <label id="26ji2"><ruby id="26ji2"></ruby></label>
                                                                        2. <mark id="26ji2"><pre id="26ji2"></pre></mark>

                                                                        3. <code id="26ji2"></code>

                                                                        4. <tt id="26ji2"><wbr id="26ji2"></wbr></tt>

                                                                          <blockquote id="26ji2"></blockquote>
                                                                        5. <label id="26ji2"><button id="26ji2"></button></label>
                                                                          
                                                                          

                                                                            1. <mark id="26ji2"></mark>
                                                                              <output id="26ji2"></output>

                                                                                  1. <listing id="26ji2"><object id="26ji2"><p id="26ji2"></p></object></listing><var id="26ji2"></var>
                                                                                  2. <listing id="26ji2"></listing>
                                                                                    <meter id="26ji2"><strong id="26ji2"><acronym id="26ji2"></acronym></strong></meter>
                                                                                    1. 
                                                                                      

                                                                                        <tt id="26ji2"></tt>

                                                                                            1. <output id="26ji2"><button id="26ji2"><address id="26ji2"></address></button></output>
                                                                                                <output id="26ji2"><pre id="26ji2"><dd id="26ji2"></dd></pre></output>
                                                                                                    <meter id="26ji2"><delect id="26ji2"></delect></meter>
                                                                                                      <label id="26ji2"></label>
                                                                                                        <mark id="26ji2"><button id="26ji2"></button></mark>

                                                                                                          <mark id="26ji2"><button id="26ji2"><address id="26ji2"></address></button></mark>

                                                                                                          1. <listing id="26ji2"><object id="26ji2"></object></listing>

                                                                                                              <tt id="26ji2"><pre id="26ji2"></pre></tt>
                                                                                                              1. <label id="26ji2"><ruby id="26ji2"></ruby></label>
                                                                                                              2. <mark id="26ji2"><pre id="26ji2"></pre></mark>

                                                                                                              3. <code id="26ji2"></code>

                                                                                                              4. <tt id="26ji2"><wbr id="26ji2"></wbr></tt>

                                                                                                                <blockquote id="26ji2"></blockquote>
                                                                                                              5. <label id="26ji2"><button id="26ji2"></button></label>
                                                                                                                
                                                                                                                

                                                                                                                  1. <mark id="26ji2"></mark>
                                                                                                                    <output id="26ji2"></output>

                                                                                                                    时时彩后三混选全包 体彩11选5选码技巧 500万彩票网app 重庆时时彩开奖直播 老重庆时时开彩结果 网上重庆时时彩怎么样? 快3大小口诀表格技巧 pk10赛车5码34567公式 幸运飞艇计划全天计划 财神捕鱼app 时时彩赛车pk10的计划 北京pk拾怎么20分钟一期了 中国体育彩票电子投注单 单机二人麻将游戏 黑红梅方最稳的压法 癸花宝典三肖六吗免费期期准